How does the latest dispensing control method control the amount of glue?Date: 2015-09-16
In the dispensing equipment industry, traditional methods are generally used to control the dispensing. Pneumatic dispensing machine controls the amount of liquid dispensed by the size of the air pressure and the opening and closing time of the air pressure; because the pressure of the assembly line fluctuates with the use of the machine, it cannot be controlled at the same air pressure. There is no way to control the uniformity of the glue. In these traditional dispensing methods, there is often no dispensing, inconsistent dispensing size, large viscosity of the glue, too slow flow rate, air bubbles in the fluid, dripping of the dispenser valve outlet, leakage of the valve body, dispenser valve or needle There are many disadvantages such as easy clogging of the mouth, tedious operation and fragile parts.
The use of XYD metering pump dispenser can solve the problem of inconsistent glue volume, the problem of large glue viscosity and too slow flow rate, and glue dripping and leaking no longer occur. Product dispensing consistency is good, bottom failure rate, suitable for products with high dispensing accuracy requirements
Xinyin Dispenser uses metering pump to discharge glue with the following advantages:
1. The gear pump has a strong rubber supply capacity, and there will be no rubber breakage or leakage;
2. PLC control can be used to store a variety of dispensing parameters, and the operation is intuitive, simple, convenient and fast;
3.Suitable for different proportions of glue
4. The glue supply is stable and the glue output is uniform;
5. Can accurately control the size of the contest and the ratio of the two-liquid glue;
6, can accurately adjust the lead time, glue time, delay time;
7, no air bubbles in the fluid;
8. The equipment has low noise, few failures, high working efficiency and long service life.
First, the XYD automatic dispenser can be operated independently without an external computer, which is convenient to install and simple to operate. Hand-held programming for teaching programming to achieve precise positioning and dispensing control of three-axis linkage,
2. Realize spatial linear interpolation or two-axis circular interpolation; teaching box with graphic button design allows you to complete
Three, with trapezoidal or S-shaped curve acceleration and deceleration function;
4. On-line teaching function of dispensing and motion mode; it can easily complete the matrix copy, offset modification, calibration point setting of various paths ...
Five, rigid structure design;
Six, with independent universal input and output;
Seven, can store multiple independent running programs;
Eight, simple programming. Operation and maintenance;
Nine, can be customized design according to different application requirements;